Differences

This shows you the differences between two versions of the page.

--- eco_fan [2024/05/02 13:18] – admin
+++ eco_fan [2024/05/02 13:30] (current) – admin
@@ Line 9: / Line 9: @@
 ###
-{{wiki:ecofan:ecofan05.jpg?200&direct}} {{wiki:ecofan:ecofan06.jpg?200&direct}} {{wiki:ecofan:ecofan07.jpg?200&direct}} {{wiki:ecofan:ecofan08.jpg?200&direct}}
+{{wiki:ecofan:ecofan05.jpg?200&direct}} {{wiki:ecofan:ecofan06.jpg?200&direct}} {{wiki:ecofan:ecofan07.jpg?200&direct}}
+###
+So what actually is an Ecofan? Put simply there are 4 essential parts: the metal [[https://en.wikipedia.org/wiki/Heat_sink|heat sink]], an electric motor, a fan and one or two [[https://en.wikipedia.org/wiki/Thermoelectric_effect|Peltier Modules]] The modules are held between the flat surfaces of the heat sinks. They are wired in series and the output feeds a small electric motor which in turn drives the fan. The stove top is the heat source which heats up the bottom heat sink. The upper heat sink has a much larger thermal area and quickly begins to reduce the temperature of the upper side of the Peltiers. Due to the [[https://en.wikipedia.org/wiki/Thermoelectric_effect|thermoelectric effect]] this creates a current flow and powers the motor which turns the fan. This disrupts the stratification and moves warmed air into the middle of the room.
+###
+{{wiki:ecofan:ecofan08.jpg?200&direct}} {{wiki:ecofan:ecofan09.jpg?200&direct}} {{wiki:ecofan:ecofan10.jpg?200&direct}} {{wiki:ecofan:ecofan11.jpg?200&direct}}
+###
+The heat sinks are reclaimed CPU heat sinks from a Dell server. The Peltiers and electric motor where sourced via eBayUK Because the fan is the one component that is difficult to fabricate accurately and symmetrically I decided to purchase that from a Caframo spares supplier in the UK. Once I had all the parts together assembly was fairly easy. I used thermal paste on either side of the Peltiers before fixing the heat sinks together using single strand 2.5mm copper wire from domestic twin & earth cable. I found this created adequate tension to hold the modules and heat sinks in place. The initial tests where done on my electric cooker griddle with the lead outs soldered together in series and an LCD multimeter measuring output. Interestingly I discovered that blowing cool air through the top heat sink increased output i.e. the greater the temperature differential, the greater the output of the cells. The wiring was put through heat resist braided glass sleeving and held neatly to the heat sink with 15 amp nickel coated copper fuse wire. The motor was mounted on a small piece of alloy plate, again by the use of 1.5mm single strand copper wire, twisted under tension.
+###
+{{wiki:ecofan:ecofan12.jpg?200&direct}} {{wiki:ecofan:ecofan13.jpg?200&direct}}
+My EcoFan in action on [[https://www.youtube.com/watch?v=iITYm7XFbPk|YouTube]]